seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Reverse gear clutch ?K2? and 3rd through 5th gear clutch ?K3? > < Installing ATF cooler

Leon Mk1

Dismantling and assembling “K1” clutch housing
Dismantling and assembling “K1” clutch housing
The clutch will now be dismantled for cleaning. No repairs can be made.
Dismantling “K1” clutch housing
–  Remove retaining ring for plates.
–  Remove plates.
   
–  Slowly and carefully press down piston cap only far enough that the ring can be removed.
–  Remove retaining ring.
–  Remove piston cap and spring.
–  Drive piston out of clutch housing.
–  To do this, gently strike a plastic mallet against the upper edge of the clutch housing.
Assembling “K1” clutch housing
–  Carefully press piston by hand into clutch housing to stop.
  N38-10043
–  Lay spring, piston cap and retaining ring in clutch housing.
–  Carefully centre piston cap before pressing it down.
–  Slowly and carefully press down piston cap only far enough that the ring can be installed.
–  Install retaining ring.
–  Install plates.
–  Install retaining ring for plates.
  N01-0453

Reverse gear clutch ?K2? and 3rd through 5th gear clutch ?K3? > < Installing ATF cooler