SEAT Workshop Service and Repair Manuals

Removing and installing mounting bracket with clutch pedal but without master cylinder Special tools and workshop equipment required

t  Torque wrench -V.A.G 1331- Removal: –  Remove driver side footwell cover → General body repairs, interior; Rep. gr.68. –  If fitted, remove clutch pedal switch -F36- → Chapter.

–  Remove the crash bar, screw -1-. Observe the nut -2-.

–  Pull bearing shaft -A- for plunger/master cylinder out of clutch pedal in -direction of arrow 1-. –  Unscrew securing bolts -arrows 2- and remove master cylinder from mounting bracket.

–  Unscrew securing nuts. –  Remove mounting bracket without master cylinder (figure shows mounting bracket with installed master cylinder).

Installation Installation is carried out in the reverse sequence; note the following:   Note Renew self-locking nut. –  Tighten securing nuts → Item.

–  Install master cylinder to mounting bracket using securing bolts -arrows 1-. Tightening torque → Item l  Always renew bearing shaft -A-. –  Press bearing shaft -A- for plunger/master cylinder into clutch pedal in -direction of arrow 2-. l  Bearing shaft -A- must audibly engage in clutch pedal. –  Test bearing shaft by tugging on it.

–  Install the crash bar, screw -1- → Item. Observe the nut -2-. –  If previously fitted, install clutch pedal switch -F36- → Chapter. –  Install driver side footwell cover → General body repairs, interior; Rep. gr.68.