SEAT Workshop Service and Repair Manuals

Renewing oil seal for selector shaft Special tools and workshop equipment required

t  Pressing-off lever -T20143/1-

t  Tube element -VW 423-

t  Torque wrench -V.A.G 1331- t  Grease -G 052 128 A1- –  First the vehicle should be checked if a coded radio is installed. If necessary obtain radio anti-theft code first. –  Remove complete air filter housing if it is located over selector mechanism → Rep. gr.24. –  Remove battery → Electrical system; Rep. gr.27. –  Remove battery tray → Electrical system; Rep. gr.27.

–  Remove securing clip -1- for gear selector cable -2- from gearbox selector lever. –  Pull gear selector cable off pin. –  Remove relay lever -3- together with cable end-piece → Fig.. –  Remove gearbox selector lever by unscrewing nut -4-.

–  Lever out seal with oil seal extractor lever -T20143/1-.

–  Pack space between sealing lip and dust lip -arrow- half full with sealing grease -G 052 128 A1-.

–  Drive seal in with tube -VW 423- onto stop. The remaining installation steps are carried out in reverse sequence - note the following points: –  Install gearbox selector lever to gearbox selector shaft → Fig.. –  Secure gearbox selector lever by tightening hexagon nut to specified torque → Item. –  Adjust selector mechanism → Chapter. –  If removed, install complete air filter housing → Rep. gr.24.