SEAT Workshop Service and Repair Manuals

Reversing light switch -F4 -: Installing and removing Check the tool and equipment equivalence table according to the applicability between Seat / VW / Audi / Skoda → Chapter Special tools and workshop equipment required

t  Torque wrench -V.A.G 1331-, see equivalent → Anchor.

Removal: –  If installed, loosen quick-type locks -3- and remove rear soundproofing -B-.

–  Unplug electrical connector -arrow- for reversing light switch - F4 - on gearbox (right-side).

–  Unscrew reversing light switch -F4- from selector shaft cover -arrow-.

Installation –  Screw reversing light switch -F4- into selector shaft cover -arrow-.

–  Disconnect connector -arrow- on right back-up lamp switch from gearbox. -F4- –  Remove previously removed rear sound-proofing

Component	Nm
Reversing light switch -F4-	20