SEAT Workshop Service and Repair Manuals

Seal for the selector rod: Replacement with gearbox installed Check the tool and equipment equivalence table according to the applicability between Seat / VW / Audi / Skoda → Chapter Special tools and workshop equipment required

t  Pipe section -VW 423-, see equivalency → Anchor

t  Release lever -T20143/1-

t  Torque wrench -V.A.G 1331-, see equivalent → Anchor. t  Slider -01E 311 120- t  Sealing grease -G 052 128 A1-

Removal:

–  If fitted, loosen quick release fasteners -3- and remove rear noise insulation -B-. –  Unscrew nut -arrow- and detach gearbox selector lever from selector shaft.

–  Carefully lever out oil seal, making sure shaft is not damaged.

Installation –  To avoid damaging oil seal -C-, oil seal and selector shaft must only be fitted using assembly sleeve -01E 311 120--A-. –  Fill half the space between the sealing lips and the dust cover with sealing grease. Allocation: →  Spare parts catalogue. –  Lightly oil outer circumference of oil seal.

–  Drive oil seal -arrow- into housing as far as it will go. The remaining installation steps are carried out in reverse sequence - note the following points: –  Remove previously removed rear sound-proofing –  Check oil level in manual gearbox → Chapter. Tightening torques

Component		Nm
Selector shaft lever to selector shaft		23
Heat shield above drive shaft to gearbox		23