seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Seal for the selector rod: Replacement with gearbox installed > < Removing and installing selector shaft of the operating unit with gearbox installed

Leon Mk1

Seal for the selector rod: Replace with the gearbox removed, but not dismantled
Seal for the selector rod: Replace with the gearbox removed, but not dismantled
  Note
Removal is also possible with gearbox installed in vehicle → Chapter.
Check the tool and equipment equivalence table according to the applicability between Seat / VW / Audi / Skoda → Chapter
Special tools and workshop equipment required
   
t  Pipe section -VW 423-, see equivalency → Anchor
  W00-0140
t  Release lever -T20143/1-
t  Slider -01E 311 120-
t  Sealing grease -G 052 128 A1-
  W00-2958
Removal:
l  With selector shaft installed
–  Carefully lever out oil seal, making sure shaft is not damaged.
  A34-0624
l  With selector shaft removed
–  Carefully lever out oil seal using a screwdriver or extractor tool -VW 681-.
  A34-0650
Installation
–  To avoid damaging oil seal -C-, oil seal and selector shaft must only be fitted using assembly sleeve -01E 311 120--A-.
–  Fill half the space between the sealing lips and the dust cover with sealing grease. Allocation: →  Spare parts catalogue.
–  Lightly oil outer circumference of oil seal.
  V34-2598
–  Drive oil seal -arrow- into housing as far as it will go.
  V34-2782

Seal for the selector rod: Replacement with gearbox installed > < Removing and installing selector shaft of the operating unit with gearbox installed