Leon Mk1
Assembly overview - hydraulics (RHD) |
1 - | Brake fluid reservoir |
2 - | Supply hose |
q | Rubber |
q | From 12.05, plastic in some vehicles → Fig. |
q | Push onto connections for brake fluid reservoir and master cylinder to stop |
q | Vehicles with turbo diesel: with hose protection |
3 - | Spring-type clip |
q | Not fitted in all vehicles |
4 - | Clutch pedal |
q | Removing and installing → Chapter |
5 - | Retainer |
q | Renew only with master cylinder removed |
q | Removing → Fig. |
q | Pressing on → Fig. |
6 - | Master cylinder operating rod |
7 - | Bolt, 10 Nm |
8 - | Master cylinder |
q | Removing and installing → Chapter |
q | With push-on connection for pipe/hose line |
q | To remove pipe/hose line, pull out clip → Item |
q | To install, push pipe/hose line in to stop and press in clip to stop |
9 - | Clip |
q | To secure pipe/hose line |
q | Removing and installing → Item |
10 - | Seal |
q | Always renew |
q | Install with master cylinder from within passenger compartment |
11 - | Mounting plate (bulkhead) |
12 - | O-ring |
q | Always renew |
q | Pull onto line connection |
q | Moisten with brake fluid before installing |
13 - | Pipe/hose line |
14 - | Retainer |
q | For pipe/hose line |
q | Attach to mounting plate |
15 - | Bolt, 8 Nm |
16 - | Union nut, 15 Nm |
17 - | Line clip |
q | For 4 lines |
18 - | Bolt, 10 Nm |
19 - | Retainer |
q | For pipe/hose line |
q | Secured to gearbox |
20 - | Gearbox |
21 - | O-ring |
q | Always renew |
q | Pull onto line connection |
q | Moisten with brake fluid before installing |
22 - | Bleeder connection |
23 - | Slave cylinder with clutch release bearing |
q | Removing and installing → Chapter |
24 - | O-ring |
q | Always renew |
q | Pull onto line connection |
q | Moisten with brake fluid before installing |
25 - | Dust cap |
26 - | Bleeder valve |
q | Bleeding clutch system → Chapter |
27 - | Clip |
q | Pull clip out to stop to remove or install pipe/hose line |