Leon Mk1
| Assembly overview - hydraulics (LHD) |
| 1 - | Brake fluid reservoir |
| 2 - | Supply hose |
| q | Push onto connections for brake fluid reservoir and master cylinder to stop |
| q | Rubber |
| q | From 12.05, plastic in some vehicles → Fig. |
| 3 - | Spring-type clip |
| q | Not fitted in all vehicles |
| 4 - | Foot pedal cluster |
| 5 - | Clutch pedal |
| q | Removing and installing → Chapter |
| 6 - | Retainer |
| q | Renew only with master cylinder removed |
| q | Removing → Fig. |
| q | Pressing on → Fig. |
| 7 - | Master cylinder operating rod |
| 8 - | Bolt, 10 Nm |
| 9 - | Master cylinder |
| q | Removing and installing → Chapter |
| q | With push-on connection for pipe/hose line |
| q | To remove pipe/hose line, pull out clip → Item |
| q | To install, push pipe/hose line in to stop and press in clip to stop |
| 10 - | Clip |
| q | To secure pipe/hose line |
| q | Removing and installing → Item |
| 11 - | Seal |
| q | Always renew |
| q | Install with master cylinder from within passenger compartment |
| 12 - | Mounting plate (bulkhead) |
| 13 - | O-ring |
| q | Always renew |
| q | Pull onto line connection |
| q | Moisten with brake fluid before installing |
| 14 - | Union nut, 15 Nm |
| 15 - | Pipe/hose line |
| 16 - | Bolt, 10 Nm |
| 17 - | Retainer |
| q | For pipe/hose line |
| q | Secured to gearbox |
| 18 - | Gearbox |
| 19 - | O-ring |
| q | Always renew |
| q | Pull onto line connection |
| q | Moisten with brake fluid before installing |
| 20 - | Bleeder connection |
| 21 - | Slave cylinder with clutch release bearing |
| q | Removing and installing → Chapter |
| 22 - | O-ring |
| q | Always renew |
| q | Pull onto line connection |
| q | Moisten with brake fluid before installing |
| 23 - | Dust cap |
| 24 - | Bleeder valve |
| q | Bleeding clutch system → Chapter |
| 25 - | Clip |
| q | Pull clip out to stop to remove or install pipe/hose line |
| 26 - | Retainer |
| q | For pipe/hose line |
| q | Secured to master cylinder on brake server |
| 27 - | Bolt, 8 Nm |
|
|
|
|
|
|
