Leon Mk1
|
1 - | Rear final drive housing → Note |
2 - | Stud, 10 Nm |
3 - | Oil drain plug, 25 Nm |
q | With magnet |
4 - | Oil filler plug, 25 Nm |
q | Capacity and specification → Chapter |
q | Check gear oil in rear final drive → Chapter |
5 - | Breather |
q | Pull out of rear final drive housing before removing differential → Item |
6 - | Retainer |
q | For wiring harness connector |
q | Various versions. |
q | Allocation → Electronic parts catalogue (ETKA) |
7 - | Hexagon bolt, 10 Nm |
q | Qty. 2 |
8 - | O-ring |
q | Always renew |
q | Coat with gear oil when installing |
q | Renewing with rear final drive installed → Chapter |
9 - | Differential, complete |
q | Remove with cover → Anchor |
q | Install with cover, tightening hexagon head bolts → Item in stages diagonally → Anchor |
q | Dismantling and assembling → Chapter |
10 - | Hexagon bolt, 25 Nm |
11 - | Right flange shaft |
q | Removing → Anchor |
q | Drive in with plastic hammer. |
12 - | Retaining ring |
q | Always renew |
q | Removing and installing → Fig. |
13 - | Bevel gear with stub shaft → Note |
q | Bevel gear with stub shaft is matched with shaft bevel gear |
q | Determine according to gearbox code using → Electronic parts catalogue (ETKA) → Chapter |
q | Repairing bearings for bevel gear with stub shaft → Chapter. |
14 - | O-ring |
q | Always renew |
q | Coat with gear oil when installing |
q | Renewing with rear final drive installed → Chapter |
15 - | Cover → Note |
q | Removing → Anchor |
q | Installing → Anchor |
16 - | Hexagon bolt, 25 Nm |
17 - | Retaining ring |
q | Always renew |
q | Removing and installing → Fig. |
18 - | Left flange shaft |
q | Removing → Anchor |
q | Drive in with plastic hammer. |
|