Set bevel box in gearbox holder on hole -arrow- marked with the number -3-.
–
Then align bevel box with remaining 3 holes and secure. Nuts -A- M 12 x 10 (Qty. 4).
–
Lock bevel box output shaft using support plate -T10108/1-.
–
Remove output flange hexagon nut.
-A- - Socket for 3/4" drive
-B- - Hexagon bolts M 8 x 25
–
Remove output flange.
–
Swing bevel box so that pinion housing -1- points upwards.
–
Pull out oil seal for output flange using multi-purpose tool -VW 771- and puller hooks -VW 771/37-, securing tapered roller bearing inner race against falling out.