Leon Mk1
Assembly overview |
Special tools and workshop equipment required |
t | Thrust plate -VW 401- |
t | Thrust plate -VW 402- |
t | Press tool -VW 412- |
t | Tube -VW 415 A- |
t | Tube -32 - 109- |
t | Splitter -3 - Kukko 17/2- |
|
1 - | Left flange shaft |
q | Removing → Anchor |
q | Drive in with plastic hammer. |
2 - | Dust plate |
q | For flange shaft |
q | Pressing off → Fig.. |
q | Pressing on → Fig. |
3 - | Seal |
q | Pry out with assembly lever |
q | Drive in to stop with drift -VW 195- |
4 - | Cover → Note |
q | Removing → Anchor |
q | Installing → Anchor |
5 - | Rear final drive housing → Note |
6 - | Shim S2 |
q | Note thickness |
q | Adjustment overview → Chapter |
7 - | Small tapered roller bearing outer race → Note |
q | Driving out → Anchor |
q | Pressing in → Anchor. |
8 - | Small tapered roller bearing inner race → Note |
q | Pressing off → Anchor. |
q | Pressing on → Anchor |
9 - | Bevel gear with stub shaft → Note |
q | Bevel gear with stub shaft is matched with shaft bevel gear |
q | Determine according to gearbox code using → Electronic parts catalogue (ETKA) → Chapter |
10 - | Large tapered roller bearing inner race → Note |
q | Pressing off → Anchor. |
q | Pressing on → Anchor |
11 - | Large tapered roller bearing outer race → Note |
q | Pulling out → Anchor |
q | Pressing in → Anchor. |
12 - | Shim S1 |
q | Note thickness |
q | Adjustment overview → Chapter |
|
|