Leon Mk1
| Assembly overview |
| Special tools and workshop equipment required |
| t | Thrust plate -VW 401- |
| t | Thrust plate -VW 402- |
| t | Press tool -VW 412- |
| t | Tube -VW 415 A- |
| t | Tube -32 - 109- |
| t | Splitter -3 - Kukko 17/2- |
|
| 1 - | Left flange shaft |
| q | Removing → Anchor |
| q | Drive in with plastic hammer. |
| 2 - | Dust plate |
| q | For flange shaft |
| q | Pressing off → Fig. |
| q | Pressing on → Fig. |
| 3 - | Seal |
| q | Levering out with assembly lever |
| q | Drive in to stop with drift -VW 195- |
| 4 - | Cover → Note |
| q | Removing → Anchor |
| q | Installing → Anchor |
| 5 - | Rear final drive housing → Note |
| 6 - | Shim S2 |
| q | Note thickness |
| q | Adjustment overview → Chapter |
| 7 - | Small tapered roller bearing outer race → Note |
| q | Driving out → Anchor |
| q | Pressing in → Anchor |
| 8 - | Small tapered roller bearing inner race → Note |
| q | Pressing off → Anchor |
| q | Pressing on → Anchor |
| 9 - | Bevel gear with stub shaft → Note |
| q | Bevel gear with stub shaft is matched with shaft bevel gear |
| q | Determine according to gearbox code using → Electronic parts catalogue (ETKA) → Chapter |
| 10 - | Large tapered roller bearing inner race → Note |
| q | Pressing off → Anchor |
| q | Pressing on → Anchor |
| 11 - | Large tapered roller bearing outer race → Note |
| q | Pulling out → Anchor |
| q | Pressing in → Anchor |
| 12 - | Shim S1 |
| q | Note thickness |
| q | Adjustment overview → Chapter |
|
|
|
|