Leon Mk1
Removing and installing gearbox housing and selector mechanism from gearbox date 13 01 3 |
1 - | Countersunk bolt, 25 Nm |
2 - | Flange shaft with compression spring |
q | Removing and installing → Chapter |
q | Assembling → Chapter |
3 - | Sealing cover |
4 - | Retaining ring |
5 - | Reversing light switch, 20 Nm |
6 - | Seal |
q | Always renew |
7 - | Oil drain plug |
q | Torque settings → Fig. |
8 - | Seal |
q | Always renew |
9 - | Locking bolt, 30 Nm |
q | For selector shaft |
10 - | Bolt, 15 Nm then turn 90° further |
q | Bolt with captive washer only as replacement part |
q | Always renew, allocation → Electronic parts catalogue (ETKA) |
q | Allocation of bolts as replacement part → Fig. |
11 - | Bolt, 15 Nm then turn 90° further |
q | Without washer |
q | Always renew, allocation → Electronic parts catalogue (ETKA) |
q | Allocation of bolts as replacement part → Fig. |
12 - | Selector mechanism |
q | Dismantling and assembling selector mechanism on gearbox side from gearbox date 13 01 3 → Chapter |
q | Removing with gearbox installed: |
t | Remove battery and battery tray |
t | Remove selector cables and gearbox selector lever |
t | Unscrew locking bolt → Item and remove selector mechanism from gearbox |
13 - | Hexagon bolt, 20 Nm |
q | Always renew |
14 - | O-ring |
q | Always renew |
15 - | Clutch housing |
q | Repairing → Chapter |
16 - | Gearbox housing |
q | Repairing → Chapter |
|