Leon Mk1
| Dismantling and assembling selector mechanism on gearbox side, through gearbox date 12 01 3 |
| Special tools and workshop equipment required |
| t | Thrust plate -VW 402- |
| t | Press tool -VW 412- |
| t | Tube -VW 421- |
| t | Tube -VW 423- |
| t | Thrust piece -VW 432- |
| t | Thrust piece -3118- |
| 1 - | Hexagon nut, 20 Nm |
| q | Self-locking |
| q | Always renew |
| 2 - | Gearbox selector lever |
| q | Install so that master spline aligns with selector shaft |
| q | Can be renewed with the selector mechanism installed |
| q | Installation position → Chapter |
| 3 - | Shoe |
| q | Clip into relay lever → Item |
| 4 - | Securing clip |
| q | Removing → Fig. |
| 5 - | Bearing bush |
| 6 - | Relay lever |
| q | Installation position → Chapter |
| 7 - | Selector mechanism cover |
| 8 - | Ball sleeve |
| q | For selector shaft |
| q | Removing → Fig. |
| q | Pressing in → Fig. |
| 9 - | Selector shaft |
| 10 - | O-ring |
| q | Always renew |
| 11 - | O-ring |
| q | Always renew |
| 12 - | Sealing cover |
| 13 - | Seal |
| q | Lever out with a screwdriver |
| q | Installing → Fig. |
| 14 - | Cap |
| q | For selector shaft |
| 15 - | Cap |
| q | For gearbox breather |
|
|
|
|
|
|
|
|
