Leon Mk1
Clutch housing - assembly overview |
1 - | Bearing sleeve for the control rods |
q | Remove → Fig. |
q | Driving in → Fig. |
2 - | Reverse gear selector fork axle |
q | Axle cannot be removed with workshop tools |
q | Fit into the clutch housing → Fig. |
3 - | Point crown for the inverter shaft |
q | Always renew if removed |
q | Remove → Fig. |
q | Driving in → Fig. |
4 - | Dowel sleeve |
q | 2 off |
5 - | clutch housing |
q | If this is replaced then the secondary differential shafts must be adjusted → Chapter |
6 - | Join ring for the input shaft |
q | Replace → Chapter |
7 - | Insert shaft oil seal |
q | replace |
8 - | Plate |
q | For the differential |
q | Fitting position: the interior diameter rebate should point towards the seal → Item |
9 - | Outer ring of roller bearing |
q | For the differential |
q | Removing and installing → Fig. |
q | If replaced the differential must be replaced → Chapter |
10 - | Oil relay washer |
q | Fitting position: the recess of the hole should face towards the secondary shaft |
11 - | Outer ring of roller bearing |
q | For 1st to 4th gear output shaft |
q | removing and fitting → Fig. |
q | If renewed: Adjust 1st - 4th gear output shaft → Chapter |
12 - | Outer ring of roller bearing |
q | For 5th/6th and reverse gear output shaft |
q | Removing and installing → Fig. |
q | If renewed: Adjust 5th/6th and reverse gear output shaft → Chapter |
13 - | Plate |
q | For 5th/6th and reverse gear output shaft |
q | 0.65 mm thick |
14 - | Cylindrical roller bearing |
q | For input shaft |
q | Removing and installing → Fig. |
15 - | Magnet |
q | Supported by the separation surface of the housing |
16 - | Cap |
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter. |
Special tools and workshop equipment required |
t | Hose clamp -T20129-, see equivalent → Anchor |
t | Tappet -T20130-, see equivalent → Anchor |
t | Extractor kit -T20140-, see equivalent → Anchor |
t | Extractor kit -T20143-, see equivalent → Anchor |
t | Kit (case) -U-40200A-, see equivalent → Anchor |
t | Tappet -U-40204-, see equivalent → Anchor |
|
|
|
Note
|
|
|