Power transmissionDifferential
| Differential: Assembly overview |

Note | t
| Whenever new gears or shafts are mounted, always consult the technical data → Chapter. |
| t
| Lubricate the bearings, mobile gears and synchromesh rings of the secondary shaft with gear oil. |
| t
| Do not mix up synchromesh rings. If re-using, allocate them to corresponding mobile pinion. |
|
|
|

| 3 - | Outer track, roller bearing |
| 4 - | Tapered roller bearing |
|
q
| If replaced, the differential crown and the secondary shaft must be replaced together. Refer to Adjustment chart → Chapter |
|
q
| Crown riveted in factory |
| 6 - | Tapered roller bearing |
| 7 - | Outer track, roller bearing |
|
q
| To house the seal for right hand flanged shaft |
| 10 - | Flanged shaft oil seal |
|
q
| Screw with threaded element to secure the articulation flanges → Item |
| 13 - | Articulation flanges |
| 14 - | Flanged shaft spring |
|
q
| Install it behind the flanged shaft |
|
q
| Installation position: Tighten facing the spring, core towards the conical ring |
|
q
| With recess for the thrust washer |
|
q
| Installation position: conical side facing the differential casing |
|
q
| Keep the following in position: conical ring, shim and spring for flanged shaft when it is dismantled |
| 18 - | Set of thrust washers |
|
q
| Impregnate with gearbox oil before installation |
| 20 - | Threaded unit for securing articulated flanges |
|
q
| Derive out using a mandrill |
|
q
| For securing differential pinion pin |
|
q
| Spring pins of different lengths have been installed |
|
q
| Spring pin identification → Fig. |
|
q
| Short spring pin: removing and fitting → Fig. |
|
q
| Long spring pin: will be cut-off for removal → Fig. |
|
q
| Clamping sleeve: Fitting → Fig. |
01 Transmission
The same page in:
Leon Mk2.