Leon Mk1
|
WARNING
|
Note
Lubricate all bearings and moving surfaces with polycarbamide grease: For correct version, refer to → Electronic spare parts catalogue „ETKA“. |
1 - | Bolt. |
q | 15 Nm |
q | replace |
2 - | Selector shaft lever |
3 - | Cable support bracket |
q | For the selector lever cable in the gearbox |
4 - | Bolt. |
q | 13 Nm |
q | For adjusting selector lever cable |
5 - | Locking plate |
q | replace |
6 - | Selector lever cable |
q | Do not bend or kink |
q | Replace the gear selection cable if the protective sheath is damaged |
q | verification and adjustment → Chapter |
q | Removing and installing, vehicles up to 02.2009 → Chapter. |
q | Do not grease the shaft ring or ball socket |
7 - | Nut |
q | 10 Nm |
q | 4x |
8 - | Rubber stop for the selector lever |
q | Clipped onto selector mechanism |
9 - | Selector lever and gear selector mechanism |
q | Operate manual release mechanism → Chapter |
q | Removing and installing → Chapter>>>>>>>> |
q | With integrated printed circuit for selector mechanism (selector lever - E313 -), do not touch |
q | Incorporates tiptronic switch -F189- and selector lever lock solenoid -N110 -. These components can be tested in the „Guided Fault Finding“ mode → Vehicle diagnostic tester. |
q | The tiptronic switch -F189- and selector lever lock solenoid -N110- can only be renewed together with the complete selector mechanism unit |
10 - | Insertion spring |
11 - | Bolt. |
q | 3.5 Nm |
12 - | Bolt. |
q | 3.5 Nm |
13 - | Insertion plate |
14 - | Bearing pin |
q | For securing selector lever cable to selector mechanism |
15 - | Retaining clip |
q | For mounting the selector lever cable to the shift unit of the operating mechanism. |
q | replace |
16 - | Panel |
q | For shift unit |
q | With gasket attached |
17 - | Nut |
q | Self-locking |
q | replace |
q | 9 Nm |
18 - | Bolt. |
q | 8 Nm + 90° |
q | replace |
q | For cable support bracket to gearbox |