SEAT Workshop Service and Repair Manuals

Dismantling and assembling outer input shaft Overview: Gearbox disassembly → Chapter. Dismantling gearbox → Chapter. Assembling gearbox → Chapter. Dismantling and assembling gearbox housing → Chapter. Dismantling and assembling clutch housing → Chapter. Dismantling and assembling inner input shaft → Chapter. Dismantling and assembling output shaft 1 - overview → Chapter. Dismantling and assembling output shaft 2 - overview → Chapter. Dismantling and assembling output shaft 3 - overview → Chapter. Notes on gearbox adjustment → Chapter. Calculating shims for clutch housing → Chapter. Calculating shims for gearbox housing → Chapter. Gearbox identification → Chapter. Code, engine allocation → Chapter.

Special tools and workshop equipment required

t	Tube -3296-

t	Attachment socket unit -T10211-

t	Tensioning tool -VW 401-

t	Tensioning tool -VW 402-

Overview 1 -  Outer input shaft 2 -  Retaining plate with screws: The lettering shows toward the gears, the smooth surface to the bearing 3 -  Bearings: Pressing off → Fig.; pressing on → Fig. 4 -  Determining thickness of retaining ring → Fig.

Outer input shaft - pressing off bearing The bearing is destroyed during pressing off and must be renewed.

Outer input shaft - pressing on new bearing to stop –  Use the tube -3296- with the attachment socket unit -T10211- for this purpose. –  Make sure that bearing is only pressed on over inner ring. l  Lettering on plate faces towards gears.

Installing retaining ring Objective is to secure bearing with retaining ring without play. To achieve this, you must select ring that fits into groove without play. –  Insert rings one after another sideways into groove. –  Select ring that is just small enough to still be installed.

–  Check that ring is located »correctly« in groove.