SEAT Workshop Service and Repair Manuals

Dismantling output shaft 2 Overview: Gearbox disassembly → Chapter. Dismantling gearbox → Chapter. Assembling gearbox → Chapter. Dismantling and assembling clutch housing → Chapter. Dismantling and assembling outer input shaft → Chapter. Dismantling and assembling inner input shaft → Chapter. Dismantling and assembling output shaft 1 - overview → Chapter. Dismantling and assembling output shaft 2 - overview → Chapter. Dismantling and assembling output shaft 3 - overview → Chapter. Notes on gearbox adjustment → Chapter. Calculating shims for clutch housing → Chapter. Calculating shims for gearbox housing → Chapter. Gearbox identification → Chapter. Code, engine allocation → Chapter.

Special tools and workshop equipment required

t	Spanner -T10061-

t	Removal equipment (ø inside diameter 25 to 155 mm) -KUKKO 15/3-

t	Removal equipment with quick-clamping spindle (ø inside diameter 25 to 155 mm) -KUKKO 17/3-

t	pressure tool -VW 416B-

t	Tappet -VW 434-

t	pressure tool -VW 447H-

t  Driving-out tool unit -VW 460- Press off bearing of output shaft 2.

–  Destroy cage of bearing first.

–  Press off bearing inner race. –  The Removal equipment (ø inside diameter 25 to 155 mm) -KUKKO 15/3- and the Removal equipment with quick-clamping spindle (ø inside diameter 25 to 155 mm) -KUKKO 17/3- can be used for this purpose. Press out using the Driving-out tool unit -VW 460-.   Note Shaft will fall down! Therefore, take precautions and position suitable items under press. It is also possible to hold shaft by hand.

Press on bearing of output shaft 2. –  Use the press tool -VW 416B- for this purpose.

–  Remove bolt. Special wrench -T10035- can also be used.

–  Press the output shaft out completely using the pressing-on tool -VW 434-.   Note Shaft will fall down! Therefore, take precautions and position suitable items under press. It is also possible to hold shaft by hand.