seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Electrical and electronic components and their locations DSG > < Removing and installing oil sump

Leon Mk1

Handle with front pushbutton
Handle with front pushbutton
With this kind of handle, the pushbutton cannot be pulled out.
There are 2 ways of moving the pushbutton into the installation position, »with« and »without« installation guard. Both of them are described here.
Place handle »with« installation guard in installation position:
   
When using the installation guard, make sure that it has an eyelet -arrow- at the front. Other types of installation guard are not suitable.
  N34-11781
–  Holding the button down, completely push in installation guard with eyelet -arrow- until the installation guard engages, then release the button. When the installation guard is pulled out, the pushbutton engages in the installation position.
Place handle »without« installation guard in installation position:
  N34-11775
–  Carefully unclip trim of handle -A- upwards.
  N37-10486
–  Using a screwdriver, press the small lever -1- for the tie rod into the groove -2-. When this is done, the pushbutton -3- is pressed into the installation position.
-I- Pushbutton in pressed position
-II- Pushbutton in installation position
  Note
t  Only press the lever into the groove and no further.
t  Do not clip the trim of the handle onto the selector mechanism until the handle has been fitted. This makes it possible to check whether the small lever engages in the tie rod when the pushbutton is pressed.
  N37-10490

Electrical and electronic components and their locations DSG > < Removing and installing oil sump