seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Initiating basic setting > < Fault table

Leon Mk1

Self-diagnosis for 5-speed automatic gearbox 09B
Erasing fault memory
Erasing fault memory

Requirement:

  • ● Fault memory interrogated .
  • ● Vehicle stationary.
  • ● Engine speed not above 960 rpm.

After fault memory has been interrogated:
 
→ Indicated on display:
Rapid data transfer     HELP
Select function XX
  • ‒ Press keys 0 and 5. (The function "Erase fault memory" is entered with 05.)
 
→ Indicated on display:
Rapid data transfer     Q
05 Erase fault memory
  • ‒ Confirm entry with key Q.
 
→ Indicated on display:
Warning!
Fault memory was not interrogated.

If the ignition was switched off e.g. between interrogating the fault memory and erasing fault memory, the fault memory is then not erased.

  • ‒ Adhere strictly to the sequence of operations, i.e. first of all interrogate fault memory.
 
→ Indicated on display:
Fault memory is not erased

If one or more faults are present.

  • ‒ Interrogate fault memory => Page 01-15.
 
→ Indicated on display:
Rapid data transfer    ⇒
Fault memory is erased!

(The fault memory will be erased approx. 5 seconds. after the display appears.)

The fault memory is now erased.

  • ‒ Press keys 0 and 6. (The function "End output" is entered with 06.)
  • ‒ Switch off ignition.

Wait about 1 minute before again interrogating the fault memory.
 
→ Indicated on display:
System cannot be interrogated!

 
→ Print out with printer switched on:
1 Fault recognized !
00811    3333
System cannot be interrogated

Control unit -J217- was not given sufficient time to recognize faults.

  • ‒ Wait about 1 minute before again interrogating the fault memory.
  • ‒ After interrogating and erasing the fault memory, carry out a test drive and again interrogate the fault memory.

When the fault memory is interrogated, the following display should appear:

    "No fault recognized!"

Initiating basic setting > < Fault table