Initiating basic setting
Initiating basic setting
The basic setting should be initiated after performing the following repairs:
-
◆ Exchanging engine
-
◆ Replacing or coding engine control unit
-
◆ Removing and installing gearbox
-
◆ Removing and installing valve chest
-
◆ Removing and installing "electronic accelerator"
-
◆ Replacing throttle valve potentiometer -G69-
-
◆ Altering throttle valve potentiometer -G69- setting e.g. when adjusting idling switch (engine)
-
◆ Removing and installing kick-down switch
-
◆ Replacing automatic gearbox control unit -J217-
=> "Special Information Bulletins" binder; Engine; No. 4
If the ATF level is correct, complaints about shift quality can, in part, also be rectified with "Basis setting".
-
‒ Connect VAS 5051 and continue to switch until the diagnosis functions are displayed => Performing self-diagnosis; 01-11.
-
‒ Press 04 - Basic setting.
-
‒ Press key 0, 0 and 0.
-
‒ Confirm entry with key Q.
-
‒ Depress accelerator pedal past kickdown to stop and hold in this position for 3 seconds.
No further display appears on tester.
The system is now in the basic setting.
|