| Cleaning norms when working in the gearbox |
| t
| Thoroughly clean unions and adjacent areas before removing. |
| t
| Place removed parts on a clean surface and cover. Use plastic or paper sheets. Do not use fluffy cloths! |
| t
| If repair work is not immediately finished, all uncovered components must be covered and stored with the utmost care. |
| t
| Only fit clean parts: only remove replacement parts from packaging immediately prior to installation. |
| t
| O-rings, seals and gaskets must always be replaced. |
| t
| To fit the O-rings, apply ATF or Vaseline so that the joints are not crushed or pinched during the installation. |
| t
| In general, only ATF should be used in the ATF areas. Other lubricants may cause irregularities in the operation of the hydraulic gearbox mechanism. |
| t
| After fitting, the level of ATF must be checked → Chapter |
|
|
|
