Leon Mk1
| Rear bumper trim: Assembly overview |
| 1 - | Expanding nut |
| q | Qty. 8. |
| 2 - | Guide profile right |
| 3 - | Bolt |
| q | Qty. 6. |
| q | 2 Nm |
| 4 - | Bolt |
| q | Qty. 2. |
| q | 20 Nm |
| q | Gas-tight threaded connections |
DANGER!
|
| 5 - | Strengthening for bumpers |
| q | Not installed for all markets. |
| 6 - | Bolt |
| q | Qty. 4. |
| q | 20 Nm |
| 7 - | Protective cover left |
| 8 - | Parking aid sender |
| 9 - | Seal |
| 10 - | Bracket (left-side) |
| q | Removing → Anchor |
| q | Installing → Anchor |
| 11 - | Bolt |
| q | Qty. 2. |
| q | 2 Nm |
| 12 - | Bolt |
| q | Qty. 4. |
| q | 2 Nm |
| 13 - | Pop rivet |
| 14 - | Rear bumper trim |
| q | Removing → Anchor |
| q | Installing → Anchor |
| 15 - | Centre support piece |
| q | Renewing → Chapter |
| 16 - | Middle protective cover |
| 17 - | Rear crossbeam |
| q | Not installed for all markets. |
| q | Removing and installing → Chapter |
| 18 - | Bracket (right-side) |
| q | Renewing → Chapter |
| 19 - | Protective cover right |
| 20 - | Guide profile right |
| 21 - | Expanding nut |