Leon Mk1
Assembly overview - door hinges |
Note
t | Only the left side is shown. Removal and installation on the right side of the vehicle are similar. |
t | The hinge bolts must always be renewed after they have been loosened. |
1 - | Front door |
q | Removing and installing → Chapter |
q | Adjusting → Chapter |
2 - | Bolt |
q | Always renew, loosening it once to adjust door is allowed. |
q | Tightening torque 50 Nm. |
q | After renewal of A-pillar the specified torque changes → Chapter. |
q | Specified torque after renewal of A-pillar: 20 Nm + 90° |
3 - | Door hinge |
q | The hinge is split. |
q | Lower part is secured to hinge upper part with bolt -5-. |
4 - | Bolt |
q | Always renew, loosening it once to adjust door is allowed. |
q | Tightening torque 50 Nm. |
q | Installed from inside vehicle. |
q | For removal and installation, A-pillar lower trim must be removed → General body repairs, interior; Rep. gr.70. |
q | After renewal of A-pillar the specified torque changes → Chapter. |
q | Specified torque after renewal of A-pillar: 20 Nm + 90° |
5 - | Bolt |
q | Connects upper part of hinge -3- to bottom part of hinge -6- |
q | Tightening torque 23 Nm. |
6 - | Door hinge |
q | The hinge is split. |
q | Upper part is secured to hinge lower part with bolt -5-. |
7 - | Bolt |
q | Always renew, loosening it once to adjust door is allowed. |
q | Tightening torque 50 Nm. |
8 - | Bolt |
q | Tightening torque 30 Nm. |
9 - | Door retaining strap |
q | Removing and installing → Chapter |
10 - | Bolt |
q | Qty. 2. |
q | Tightening torque 9 Nm. |
11 - | Door hinge |
q | The hinge is split. |
q | Upper part is secured to hinge lower part with bolt -16-. |
12 - | Bolt |
q | Always renew, loosening it once to adjust door is allowed. |
q | Tightening torque 50 Nm. |
13 - | Bolt |
q | Always renew, loosening it once to adjust door is allowed. |
q | Tightening torque 50 Nm. |
q | After renewal of A-pillar the specified torque changes → Chapter. |
q | Specified torque after renewal of A-pillar: 20 Nm + 90° |
14 - | Door hinge |
q | The hinge is split. |
q | Lower part is secured to hinge upper part with bolt -16-. |
15 - | Bolt |
q | Always renew, loosening it once to adjust door is allowed. |
q | Tightening torque 50 Nm. |
q | Installed from inside vehicle. |
q | To remove and install, the dash panel must be removed → General body repairs, interior; Rep. gr.70. |
q | After renewal of A-pillar the specified torque changes → Chapter. |
q | Specified torque after renewal of A-pillar: 20 Nm + 90° |
16 - | Bolt |
q | Connects upper part of hinge -3- to bottom part of hinge -6- |
q | Tightening torque 23 Nm. |