seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Removing and installing rear side-airbag crash sensor, driver sideG256 > < Required special tools, workshop equipment, test and measuring devices and auxiliary items

Leon Mk1

Removing and installing front airbag crash sensor, driver sideG283
Removing and installing front airbag crash sensor, driver side -G283-
  Note
The crash sensor for front airbag on driver's side -G283- is located on the tension strut behind the SEAT emblem in radiator grille.
Removing
  WARNING
Observe the general safety regulations when working on airbag, belt tensioner and battery isolator units (pyrotechnic components) → Chapter
–  Disconnect vehicle battery → Electrical system; Rep. gr.27.
–  Remove radiator grille → General body repairs, exterior;; Rep. gr.66.
   
–  Undo bolt -1- (6 Nm) and remove crash sensor for front airbag on driver's side -G283- from tension strut.
–  Release connector locking mechanism and pull off connector -2- of front airbag crash sensor on driver's side -G283--3-.
Installing
–  Install in reverse order of removal.
–  Switch on ignition.
  WARNING
Ensure that nobody is in vehicle.
–  Reconnect vehicle battery → Electrical system; Rep. gr.27.
  N69-10536

Removing and installing rear side-airbag crash sensor, driver sideG256 > < Required special tools, workshop equipment, test and measuring devices and auxiliary items