seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Removing and installing Rear side airbag crash sensor on front passenger sideG257 > < Removing and installing front airbag crash sensor, driver sideG283

Leon Mk1

Removing and installing rear side-airbag crash sensor, driver sideG256
Removing and installing rear side-airbag crash sensor, driver side -G256-
  Note
Rear side airbag crash sensor on driver side -G256- is located in front of rear wheel housing on driver side.
Removing
  WARNING
Observe general safety regulations when working on airbag, belt tensioner and battery isolator units (pyrotechnic components) → Chapter.
–  Disconnect vehicle battery → Electrical system; Rep. gr.27.
–  Remove CD changer if there is one → Communication; Rep. gr.91.
–  Remove seats of third row of seats → Chapter.
–  Detach C-pillar trims → Chapter.
–  Remove roof end strip → Chapter.
–  Remove D-pillar trims → Chapter.
–  Removing lock carrier cover → Chapter.
–  Remove connecting piece between sill panel strip and luggage compartment trim → Chapter.
–  Remove luggage compartment side trim → Chapter.
   
–  Release connector locking device and pull connector -1- off crash sensor -3-.
–  Undo the screw -2- (6 Nm).
Installing
–  Install in reverse order of removal.
–  Switch on ignition.
  WARNING
Ensure that nobody is in vehicle.
–  Reconnect vehicle battery → Electrical system; Rep. gr.27.
  N69-10344

Removing and installing Rear side airbag crash sensor on front passenger sideG257 > < Removing and installing front airbag crash sensor, driver sideG283