Removing and installing front seat cushion cover and padding |
Note Removal and installation is described for the left seat. Apply the same instructions for removal and installation of right seat components as appropriate. |
WARNING If the front passenger seat cushion padding is renewed, the seat occupied sensor, front passenger side -G128- must also always be renewed → Chapter. |
|
–
| Attach seat repair stand -VAS 6136- to engine and gearbox support -VAS 6095-. |
–
| Fasten seat on seat repair stand -VAS 6136-. |
–
| Remove drawer mounting if there is one → Chapter. |
Front passenger seat without height adjustment |
Front passenger seat with through-loading aperture |
–
| Remove trim bracket on sill side → Chapter. |
Front seats with manual height adjustment |
–
| Remove trim bracket on sill side → Chapter. |
Driver seat, electrically adjustable |
–
| Remove trim bracket on sill side → Chapter. |
–
| Disconnect the two backrest drive wiring harnesses from seat frame on lower side. Detach wiring harnesses from seat frame. |
–
| Cut through cable ties of braided hose and pull wiring harness of side airbag through hose. |
Note In vehicles fitted with a through-loading aperture, it is sufficient to fold the backrest forwards. It is not necessary to remove the backrest. |
|
|
|