seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

Installing > < Removing and installing assembly carrier 06.00 ?
Removing
Removing
–  Remove dash panel 06.00 ► → Chapter.
   
–  Remove screws -arrows-.
–  Remove screws -1- and -2-.
–  Remove bolt -3-.
–  Take off upper and lower parts of steering column trim -4- and -5-.

   
–  Remove screws -1- (qty. 4).
–  Unscrew nuts -2- (qty. 3) and separate earth lead from assembly carrier.

   
–  Remove screws -1- and -2-.

   
–  Unhook springs -1- and -2- with aid of long-nose pliers.
–  Drill out shear bolts -3- and -5-.
–  Remove bolt -4-.

   
–  Disengage tabs -1- and -2-.
–  Unscrew bolt -3- and release relay board from assembly carrier.

   
–  Remove two bolts -1- above steering column.
–  Unscrew two bolts -2- on right edge of assembly carrier.
–  Remove bolt -3-.
–  Unscrew two bolts -4- on left edge of assembly carrier.
–  Take assembly carrier out of vehicle.

   

Installing > < Removing and installing assembly carrier 06.00 ?