seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Upper C-pillar trim, Model ST: Assembly overview > < B-pillar trim, 5-door vehicles: fitting Assembly overview

Leon Mk1

B-pillar trim, 5-door vehicles: fitting Removing and installing.
B-pillar trim, 5-door vehicles: fitting Removing and installing.
Special tools and workshop equipment required
   
t  Torque wrench kit -SAT 8010-
  L00-10226
t  Release lever -T20043-
  W00-2324
t  Release lever -U30800-
  W00-2169
Removal:
  Note
The procedures for removal and assembly described below correspond to the upper lining of strut C on the left. The procedures for the right-hand side are similar.
–  Remove the rear tray.
–  Fold down rear bench seat on left side.
–  Fold down the rear seat back.
–  Place the lever -U 30800- in the notch on the diffusion glass and carefully lever out the luggage compartment light -7-.
–  Unplug connector -6-.
–  Remove bolt from the side rear safety belt fitting -5- → Item.
–  Remove bolts -4-.
–  Detach lining -1- from the clip fasteners -2- and -3- using the lever -T20043- and remove the lining.

Installation
Installation is carried out in the reverse order. When installing, note the following:
  Note
Before fitting the lining check the condition of the clips and replace if necessary.
   

Upper C-pillar trim, Model ST: Assembly overview > < B-pillar trim, 5-door vehicles: fitting Assembly overview