seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Lower C-pillar trim: Assembly overview > < Upper C-pillar trim, Model ST: Assembly overview

Leon Mk1

Upper C-pillar trim, Model ST: Removing and installing.
Upper C-pillar trim, Model ST: Removing and installing.
Special tools and workshop equipment required
   
t  Release lever -T20043-
  W00-2324
t  Release lever -U30800-
Removal:
  Note
The procedures for removal and assembly described below correspond to the upper lining of strut C on the left. The procedures for the right-hand side are similar.
  W00-2169
–  Remove the rear tray.
–  Remove the idle pulley from the compartment → Chapter.
–  Slacken the lining -2- from the attachment of clip -1- using the lever -T20043- and remove the lining downwards.
Installation
Installation is carried out in the reverse order. When installing, note the following:
  Note
Before fitting the lining check the condition of the clips and replace if necessary.

   

Lower C-pillar trim: Assembly overview > < Upper C-pillar trim, Model ST: Assembly overview