Leon Mk1
Roof edging: removing and fitting |
Note
The roof edging is not to be refiitted. |
1 - | Roof edging |
q | Removing |
– | Remove the Allen bolts → Item and the Phillips screws → Item. |
– | Remove the final hood → Item and slide the the two runners along the roof edging → Item while pressing the button (with the help of a second operater). |
2 - | Runner |
q | Removing: |
– | Remove the Allen bolts → Item and the Phillips screw → Item. |
– | Remove the covers from the ends → Item and slide the runners along the the roof edging → Item while pressing the button. Ensure that the beam → Item does not fall onto the roof. |
3 - | Front beam |
q | When assembling, observe the mark on the lower side which indicates the installation position. |
4 - | Roof moulding |
q | Remove the roof edging → Item in order to dismantle |
q | Removing and fitting: → Item |
5 - | Star head bolt |
q | Tightening torque: 3.5 Nm |
6 - | Rear beam |
q | When assembling, observe the mark on the lower side which indicates the installation position |
7 - | Allen bolt |
q | Tightening torque: 5.5 Nm |
8 - | T-shaped bolt with thread |
9 - | Final hood |
10 - | Clip |