ATF pipes, ATF cooler and additional ATF filter: repairs |
Note t
| Cleaning norms when working on automatic gearbox. → Chapter |
t
| Before fitting a replacement gearbox, always blow through the ATF cooler and ATF pipes with compressed air (not more than 10 bar) and renew the supplementary ATF filter → Chapter. If the ATF which emerges during cleaning is very dirty, the ATF cooler and ATF lines must additionally be flushed out with clean ATF. |
t
| To install, first press ATF pipes onto gearbox or cooler by hand until they engage, then bolt on. |
|
|
|