Removing and installing engine
Notes on installing
Installation is carried out in the reverse sequence, when doing this note the following:
Vehicles with manual gearbox
-
‒ Check release bearing in slave cylinder for wear, renew slave cylinder with release bearing if necessary.
-
‒ Clean input shaft splines and lightly grease with G 000 100.
Continuation for all vehicles
-
‒ Check whether the dowel sleeves for centring engine/gearbox are in the cylinder block and install if necessary.
-
‒ Screw in all bolts on assembly mountings by hand approx. 5...6 turns.
-
‒ Align assembly mountings stress-free by rocking.
Note:
Assembly mounting tightening torques
.
-
‒ Install pendulum support:
=> Running gear; Repair group 40; Servicing front wheel mounting; I - Assembly overview, assembly carrier, anti-roll bar, wishbone
-
‒ Installing air conditioner compressor:
=> Heating, Air conditioning; Repair group 87; removing and installing compressor bracket
Vehicles with manual gearbox
-
‒ Connect pipe/hose on slave cylinder and secure with clip:
=> 5-Speed manual gearbox 006; Repair group 30; Assembly overview; hydraulics and clutch release mechanism
-
‒ Attach operating cable to gearbox, adjust if necessary:
=> 5-Speed manual gearbox 006; Repair group 34; Servicing selector mechanism; Removing and installing operating cables
=> Running gear; Repair group 40; Servicing drive shafts; Removing and installing drive shafts
Vehicles with automatic gearbox
-
‒ Install selector cable on gearbox, adjust if necessary:
=> Automatic gearbox 099; Repair group 37; Servicing selector mechanism
=> Running gear; Repair group 40; Servicing drive shafts; Removing and installing drive shafts.
Continuation for all vehicles
-
‒ Install P.A.S. vane pump with bracket:
=> Running gear; Repair group 48; Assembly overview: vane pump, reservoir, hydraulic pipes; Installing vane pump.
-
‒ Install front exhaust pipe => Page 26-2, removing and installing parts of exhaust system.
-
‒ Fill with coolant => Page 19-10
-
‒ Electrical connections and routing:
=> Current flow diagrams, Electrical fault finding and Fitting locations
-
‒ Matching engine electronics control unit to electronic immobilizer
=> Repair group 23; Servicing Diesel direct injection system; Matching engine electronics control unit to electronic immobilizer
-
‒ Interrogate fault memory:
=> Repair group 01; Self-diagnosis; Interrogating fault memory
|