SEAT Workshop Service and Repair Manuals

(with cylinder head fitted)

Special tools, testers and auxiliary items

• ◆ Puller 3047A
• ◆ Assembly tool 2036
• ◆ Lever VW 541/1A with press piece VW 541/5

Valve stem ø 8 mm:

• ◆ Fitting tool 3129

Valve stem ø 7 mm:

• ◆ Fitting tool 3129

Removing

• ‒ Remove camshaft .
• ‒ Remove bucket tappets (do not interchange) and store with the contact surface downwards.
• ‒ Set piston of respective cylinder to top dead centre (TDC).
• ‒ → Fit assembly tool 2036 and adjust mountings to height of studs.
• ‒ Remove valve springs with lever VW 541/1A and press piece VW 541/5.

Note:

The valves are supported by the piston crown.

• ‒ → Pull off valve stem seals with 3047A.

Installing

• ‒ → To prevent damage to the new valve stem seals, place plastic sleeve -A- on valve shaft.
• ‒ Oil valve stem seal -B-, place it in tool
      Valve shaft ø 8 mm: 10-204
      Valve stem ø 7 mm: 3129
  and push carefully onto the valve guide.