SEAT Workshop Service and Repair Manuals

Notes:

• ◆ Removing and installing exhaust manifold , Removing and installing turbocharger with attachments.
• ◆ After working on the exhaust system ensure that the system is not under stress, and that it has sufficient clearance from the bodywork. If necessary, loosen clamps and align silencer so that sufficient clearance is maintained to the bodywork and the support rings are evenly loaded.
• ◆ Renew self-locking nuts.

Front exhaust pipe and catalyst with attachments

• Heat shield
• Sheet metal nut
• ◆ Must be screwed-on/off
• Front exhaust pipe
• Gasket
• ◆ Renew
• Retaining ring
• ◆ Renew if damaged
• Heat shield
• Catalyst
• To front silencer
• ◆ , item 7
• 25 Nm
• From turbocharger

Silencer with mountings

Note:

Align the exhaust system longitudinally so that the dimensions -a- and -b- are maintained.

• From catalyst
• ◆ => Page 26-2, item 7
• Clamp
• 40 Nm
• ◆ Renew
• Retaining ring
• ◆ Renew if damaged
• ◆ Note fitting position
• Sheet metal nut
• ◆ Must be screwed-on/off
• Heat shield

• Front silencer
• Rear silencer
• ◆ Engine codes AFN, AVG with twin end pipes
• Dimension -b- = approx. 50 mm
• Dimension-a- = ca. 5 mm