SEAT Workshop Service and Repair Manuals

When working on the engine, it should be secured to the assembly stand support clamp VW 313 using the engine and gearbox bracket VW 540 and supplementary set VW 540/1B.

Work sequence

• ‒ Remove gearbox.

Vehicles with automatic gearbox

• ‒ Secure torque converter against "falling out" after separating engine from gearbox.

Continuation for all vehicles

• ‒ Bolt engine/gearbox bracket VW 540 with supplementary set VW 540/1 B onto cylinder block.
• ‒ → Attach lifting device 2024 A as follows and lift engine out of engine/gearbox jack using workshop crane.

    Pulley end:
    4th hole in hook at position 1

    Flywheel end:
    4th hole in hook at position 8

Notes:

• ◆ The positions marked 1...4 on the bar must be towards the pulley end.
• ◆ The holes in the hook rails are counted up from the hook.

• ‒ Fit engine in support clamp VW 313 using workshop crane V.A.G 1202 A.