SEAT Workshop Service and Repair Manuals

Note:

For repairs to the clutch:

=> 6-speed manual gearbox 02N; Repair group 30; Servicing clutch

• 90 Nm + 1/4 turn (90 °) further
• ◆ Renew
• ◆ Threads and shoulder must be free of oil and grease
• ◆ Counter-hold with 3415 to loosen and tighten
• Crankshaft toothed belt sprocket
• 15 Nm
• Oil seal
• ◆ Renewing

• Front sealing flange
• ◆ Must be located on dowel sleeves
• ◆ To remove and install remove sump
• ◆ Insert with silicone sealant
  D 176 404 A2
  => Page 13-21
• ◆ Removing and installing
  => Page 13-21
• Cylinder block
• ◆ Removing and installing crankshaft => Page 13-28
• ◆ Dismantling and assembling pistons and conrods
  => Page 13-33
• 60 Nm + 1/4 turn (90 °) further
• ◆ Renew
• Flywheel/drive plate
• ◆ To remove or install flywheel, hold with counter-hold tool 3067
• ◆ Removing and installing drive plate

• Intermediate plate
• ◆ Must be located on dowel sleeves
• ◆ Do not damage/bend when assembling
• Sealing flange with oil seal
• ◆ Only renew complete
• ◆ To remove and install remove sump
• ◆ Use protective sleeve supplied when installing
• ◆ Do not additionally oil or grease the oil seal sealing lip
• ◆ Before installing, remove oil remains from crankshaft journal with a clean cloth
• ◆ Remove protective sleeve first after sealing flange has been slid onto crankshaft journal