SEAT Workshop Service and Repair Manuals

Special tools, testers and auxiliary items

• ◆ Retainer 3273
• ◆ Oil seal extractor 3203
• ◆ Pressure sleeve 3266
• ◆ Torque wrench V.A.G 1332 (40 - 200 Nm)

Removing

• ‒ Remove ribbed belt .

• ‒ → Remove vibration damper. To do this lock vibration damper with 3273.
• ‒ Unscrew inner part of oil seal extractor 3203 three turns (approx. 4 mm) out of the outer part and lock with knurled screw.
• ‒ Lubricate threaded head of oil seal extractor, place it in position and exerting firm pressure screw it as far as possible into oil seal.
• ‒ Loosen knurled screw and turn inner part against crankshaft until the oil seal is pulled out.

Installing

Note:

→ A PTFE seal (Teflon) -2- has been introduced gradually to replace the coil spring seal -1-. The seal has a wider sealing lip. PTFE seals are fitted free of oil or grease.

If a PTFE seal is installed then only such a seal may be used as a spare part.

• ‒ Before installing, remove oil remains from crankshaft journal with a clean cloth.
• ‒ → Place guide sleeve T10053/1 at front onto crankshaft journal and carefully slide seal over guide sleeve as far as possible onto crankshaft journal.
• ‒ Remove assembly tool.

• ‒ → Press oil seal in onto stop with press sleeve from 3266. To do this use an old vibration damper securing bolt.

• ‒ → Install vibration damper and lock with counter-hold tool 3273.
• ‒ Tighten new securing bolt to 100 Nm and then turn
      1/4 turn (90°)
  further.

Notes:

• ◆ Renew securing bolt.
• ◆ When tightening the securing bolt the crankshaft must not turn.

• ‒ Install ribbed belt => Page 13-22.