SEAT Workshop Service and Repair Manuals

Notes:

• ◆ For repairs to the clutch:

=> 5 Speed manual gearbox 006; Repair group 30; servicing clutch

• ◆ The sealing flange (Pos. 7) can be removed and installed with the cylinder head fitted.
• ◆ When stripping and assembling the engine it should be secured to the engine frame with engine bracket 3269.

• 100 Nm + 1/4 turn (90 °) further
• ◆ Renew
• ◆ Counter-hold with 3273 to loosen and tighten , replacing crankshaft oil seal, vibration damper end

• Vibration damper
• 10 Nm
• Oil seal
• ◆ Renewing
• Sealing flange
• ◆ Coat sealing surfaces with
  AMV 188 001 02
• Cylinder block
• ◆ Removing and installing crankshaft => Page 13-46
• ◆ Dismantling and assembling pistons and conrods
  => Page 13-49
• Sealing flange
• ◆ Coat sealing surfaces with
  AMV 188 001 02

• Oil seal
• ◆ Remove with 2086
• ◆ Only for coil spring seal: Oil sealing lip and pull in with press sleeve 2003/3
• ◆ PTFE version of oil seal
• ◆ Identification: no inner coil spring
• ◆ Do not additionally oil or grease the oil seal sealing lip
• ◆ Before installing, remove oil remains from crankshaft journal with a clean cloth
• ◆ Install over sleeve 2003/2A
• ◆ Pull in onto stop with press sleeve 2003/1
• Flywheel/drive plate
• ◆ To remove and install counter-hold with VW 558
• ◆ Removing and installing drive plate

• 60 Nm + 1/4 turn (90 °) further
• ◆ Renew
• 25 Nm
• Bracket
• ◆ For coolant hose