→ Fig. 1 Connection for heater element N79
Heater element N79 has a resistance of Specification: 7...12 ω at an ambient temperature of about 25 °C.
When checking voltage supply:
-
‒ Mark connector -1- (danger of interchanging).
-
‒ Pull off 2-pin connector and take measurement with ignition switched on at connector contacts 1 + 2.
Specification: at least 11.5 V
If the specification is obtained:
-
‒ Check wiring from contact 1 to fuel pump relay (J17) according to current flow diagram.
=> Current flow diagrams, Electrical fault finding and Fitting locations
|