Leon Mk1
Note!
|
1 - | Air distributor housing |
2 - | Left temperature trap |
q | Displayed in “cooling” position |
3 - | Air flow to the centre console rear vent air duct and to the centre vents of the instrument panel |
4 - | Air flow to the centre console rear vent air duct and to the centre vents of the instrument panel |
5 - | Right temperature flap |
q | Displayed in centre position |
6 - | Left foot well temperature trap |
q | Displayed in “closed” position |
q | The centre vents (left, right and middle) and the vents in the foot well area are operated by the cam disks on the servomotor or the shaft |
7 - | Left foot well air duct |
8 - | Air distribution housing with cross section made by the line “A” - “A” |
9 - | Additional heating element (00402) -Z35- with Additional air heating control unit (00483) -J604- |
q | Not fitted in all vehicles |
q | Only for vehicles fitted with a diesel engine, depending on the vehicle equipment there is an additional electric heating |
10 - | Heating heat exchanger |
11 - | Air intake for the evaporator housing |
12 - | Right temperature flap |
q | Displayed in centre position |
13 - | Right foot well temperature trap |
q | Displayed in “closed” position |
q | The centre vents (left, right and middle) and the vents in the foot well area are operated by the cam disks on the servomotor or the shaft |
14 - | Deicing vent |
q | Displayed in “closed” position |
15 - | Air distribution housing with cross section made by the line “B” - “B” |
16 - | Centre flap “centre” |
q | Displayed in “open” position |
q | The centre vents (left, right and middle) and the vents in the foot well area are operated by the cam disks on the servomotor or the shaft |
17 - | Flap in the air flow duct to the centre console rear vent |
q | This flap is operated by a transmission lever from the centre flap |
18 - | Air flow duct to the centre console rear vent |
q | Now, this duct is closed by a plug |
q | Use of a vent in the centre console still not realised |