t
| Take special care when fitting the circlip -A- that it is not bent any more than is necessary for fitting. |
–
| Fit the circlip -A- on the correct side, the side with the insertion rebate -C- should be on the side facing away from the compressor (the flat side faces the compressor). |
–
| Fit the rubber buffer elements -D- as shown in the diagram to the pulley -B-. |
–
| Damp the rubber buffer elements -D- slightly for fitting, for example using a wheel fitting paste or even a soap solution (lubrication for fitting). |
Note! The rubber buffer elements must be fitted to the pulley in such a way that the arrow points to the exterior. |
|
|
|