seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Supplementary heating element Z35 : removing and fitting > < Supplementary heating element Z35 : checking

Leon Mk1

Removing
Removing
–  Remove the driver side stowage compartment and glove box: → Bodywork, interior fitting work; Rep. Gr.68
–  Remove the central console and gear control
   
–  Remove the bolts -B- and the complete instrument panel support -A- → Bodywork, interior fitting work; Rep. Gr.70
–  Release the supplementary heating earth connection on the central bridge. → Rep. Gr.01
  E80-0055
–  Disconnect the connector -A-.
–  Remove the bolt -C-.
–  Dismount the heating duct to the rear seat compartment (not fitted in all vehicles).
  E80-0056
–  Remove the clips -A-.
–  Remove the lower section of the air flow casing -B- (with the supplementary heating element -Z35-), moving it in the direction of the arrow.
–  Remove the supplementary heating element -A- from the lower section of the air flow casing -B-.
  Note
t  The hear exchanger -C- remains assembled.
  E80-0057
t  There are two different versions of air flow casing -B- (with and without opening for the supplementary heater element -Z35-).
  E80-0058

Supplementary heating element Z35 : removing and fitting > < Supplementary heating element Z35 : checking