SEAT Workshop Service and Repair Manuals

Modifying gearbox holder 2004

Sequence for dismantling and assembling => page 34-95

• Slave cylinder with release bearing
• O ring
• ◆ Always renew
• Spring pin
• ◆ Removing and installing
  => from Page 34-95
• Clutch housing
• ◆ Servicing => page 34-106
• Differential
• ◆ Dismantling and assembling => page 39-8

• Output shaft
• ◆ Dismantling and assembling => Page 35-20
• Input shaft
• ◆ Dismantling and assembling => Page 35-1
• Magnet
• ◆ Held in place by housing joint surface
• Gearbox housing
• ◆ Servicing => page 34-106
• Hexagon bolt, 30 Nm
• ◆ Qty. 19
• Hexagon bolt, 30 Nm
• Hexagon bolt, 10 Nm

• Selector mechanism
• ◆ Coat sealing surface with
  AMV 188 200 03
• ◆ Secure to gearbox in position "neutral"
• Thrust washer
• ◆ Installation position:
  Tab towards mounting bracket
• Reverse gear
• ◆ Installation position:
  Shoulder towards mounting bracket
• Needle bearing for reverse gear
• Thrust washer
• ◆ Installation position:
  Tab towards mounting bracket
• Mounting bracket
• Hexagon bolt, 35 Nm
• ◆ Insert with locking fluid D 000 600

• Selector fork, 5th and reverse gear
• Selector fork, 3rd and 4th gear
• Selector rod, 3rd and 4th gear
• Selector rod for 5th and reverse gear as well as 1st and 2nd gear
• Selector fork, 1st and 2nd gear
• Speedometer drive
• ◆ Can also be replaced if gearbox is installed
• O ring
• ◆ Always renew
• Sealing cuff
• Hexagon bolt, 10 Nm