SEAT Workshop Service and Repair Manuals

→ To secure the automatic gearbox 006 to assembly bracket a new hole is required in gearbox holder 2004.

Dimensions given are in mm.

• ‒ Mark position of hole (arrow A) as per illustration.
• ‒ Drill a 13 mm ø (arrow A) in gearbox holder 2004.

Use new hole (arrow A) and provided hole (arrow B) to secure gearbox to gearbox holder 2004.

Note:

Older gearbox holders may require the angled section (arrow) be reworked.

• ‒ Check gearbox holder 2004 is to dimension "45" and at an angle of 30°, modify if necessary.