SEAT Workshop Service and Repair Manuals

Note:

The selector mechanism is dismantled as follows:

• ‒ Remove gear shift lever (item 21) and reversing light switch (item 19), unscrew switch pin (item17).
• ‒ Separate selector mechanism cover (item 5) from gear shift gate (item13) (4 bolts).
• ‒ Remove securing clips (items 9 and 18).
• ‒ Remove hexagon bolt for selector finger (item11) and pull out selector shaft (item10).

• Hexagon bolt, 30 Nm
• Lock washer
• Selector lever
• Clip
• Selector mechanism cover
• Spring
• Spring
• Washer
• Securing clip
• Selector shaft
• Selector finger
• Stop
• Gear shift gate
• ◆ With stop for reverse gear

• Hexagon bolt, 10 Nm
• ◆ Qty. 4
• Ball sleeve
• ◆ Removing and installing => Fig.1
• Hexagon bolt, 30 Nm
• Switch pin
• ◆ For reversing light switch
• Securing clip
• Reversing light switch
• ◆ Install in neutral position
• Oil seal
• ◆ Lever out with screwdriver
• ◆ Driving in => Fig.3
• Gear selector lever

→ Fig.1    Removing and installing ball sleeve in selector cover

Installation position: side with writing towards thrust piece

→ Fig.2    Removing and installing ball sleeve for gear selector gate

Installation position: side with writing towards thrust piece

→ Fig.3    Insert oil seal in onto stop