Leon Mk1
Servicing gear selector mechanism
Removing and installing operating cables
|
Removing Note: Note radio coding for vehicles with coded radio.
=> Electrical system; Repair group 27
|
|
|
|
Note: If the shield cannot be slid rearwards then the exhaust system is to be separated before the catalyst and the shield removed. |
|
|
|
|
|
Installing Installation is carried out in the reverse sequence, when doing this note the following: |
|
→ Installation position: The gear selector cable -A- crosses over the gate selector cable -B-.
|
|
|
The spring presses the locking mechanism into normal position.
|
Tightening torque → Reinforcing strut under dash panel to body: 20 Nm |