SEAT Workshop Service and Repair Manuals

• Gear stick knob
• Spring
• Release for reverse gear
• Cover
• ◆ Before installing, connect to release for reverse gear =>Page 34-14
• Cable tie
• Gearbox selector lever
• Bolt, 25 Nm
• Gear stick housing - upper section

• Rubber mounting
• ◆ Only fits in one position
• O ring
• ◆ Always renew
• Bush
• ◆ Removing =>Fig.1
• O ring
• ◆ Always renew
• Ball cup
• ◆ To mount gear stick
• Rubber mounting
• ◆ Only fits in one position
• Gate selector bracket
• Fulcrum pin
• Gear stick housing - lower section

• Square head bolt
• ◆ Qty. 4
• Gasket
• ◆ Qty. 4
• Spring
• Washer
• Gasket
• Reinforcing plate
• Self-locking hexagon nut, 10 Nm
• ◆ Qty. 4
• Mounting
• ◆ For gear selector cable to gear change lever
• Bush
• Mounting
• ◆ For gate selector cable to gate selector bracket

• Gate selector cable
• ◆ The cables cannot be separated from one another
• ◆ Always remove and install together =>Page 34-17
• Gear selector cable
• ◆ The cables cannot be separated from one another
• ◆ Always remove and install together =>Page 34-17

→ Fig.1    Lever bush off in direction of arrow