Leon Mk1
Gearbox casing and 5th gear cover: repairing |
Special tools and workshop equipment required |
t | Gearbox repair set -U-40200- |
t | Threaded taps with hammer -U-40087- |
t | Tool for fitting/removing clutch lever shaft bushes -T20061- |
1 - | Sealing cap |
q | Renew |
q | Removal: pierce and lever out |
q | Fit → Fig. |
2 - | Safety clip |
3 - | Clutch lever |
q | It fits in only one position |
4 - | Recoil spring |
5 - | Clutch relase collar |
q | Can be replaced with the gearbox in place |
6 - | Oil seal |
q | Fit → Fig. |
q | Can be replaced with the gearbox fitted, removing the clutsh release shaft |
7 - | Clutch release shaft |
q | Removal: remove the stop item → Item, the lid → Item and the safety clip item 2, and remove the shaft |
8 - | Stop |
9 - | Gearbox casing cover |
q | As a spare, only the model with bushes is supplied |
10 - | Oil drain screw, 25 Nm |
q | 25 Nm |
q | Without magnet |
Note!
|
|